5303935108 Electrolux/Frigidaire Range (Stove, Oven) Timer Repair

Failure codes, problems, and resolutions for Electrolux/Frigidaire timer model # 5303935108

Electrolux ERCs and Electrolux stove clocks and timersFrigidaire ERCs and Frigidaire stove clocks and timers Manufacturer :  Electrolux/Frigidaire
Part Number :  5303935108
Appliance Type :  Range (Stove, Oven)
Color : 
Description :  Clock/timer

 
 
Do you have a failed Electrolux/Frigidaire 5303935108 timer?
Click here:

We can repair or replace your faulty 5303935108 timer.
Request Appliance Timer Service

Clock/timer timer Part Number 5303935108 is used in the following appliances

Recent Service Requests for Electrolux/Frigidaire Part Number 5303935108

CityModel NumberFailure CodeProblem DescriptionResolution
Nevada, IowaFEF367CATBN/AThe relay closes for the bake cycle but does not open at the set temperature. The bake element stays on all the time during the bake cycle. If cancel is pushed it will shut off. When the bake cycle is put on you can watch as the digital temperature increases to the set temperature then stops. However the element continued to heat until manually turned off.Awaiting receipt of timer
Decatur, IllinoisFEF377BADAN/AOver and self-clean do not work, nor does the timerAwaiting receipt of timer
Bloomington, IndianaFEF377BADAF3The timer signals "F3"(and beeps) a few seconds after "Broil" or "Bake Temp" is selected, and the oven just barely starts to heat. Incorrect information suggested that the temperature probe was bad. That was not the problem -- apparently, it's the timer. In removing the timer, I mistakenly separated the circuit boards, and lost two small washer/spacers. I reassembled the timer, but the middle two screws that join the boards are missing those two small washer/spacers. I also found an extra 5/8" dark grey spacer. I have no idea where it belongs, and I hope it, and possible a missing mate, are not essential for my re-installation of the timer.Repaired
woodbridge, VirginiafrigidaireN/Amotor will not stopBeyond Repair
East Greenville, PennsylvaniaFEF377BADANO FAULT CODESThe relay closes for the bake cycle but does not open at the set temperature. The bake element stays on all the time during the bake cycle. If cancel is pushed it will shut off. I checked the temperature probe resistance with an ohm meter and it meets the specs in the service data sheet. When the bake cycle is put on you can watch as the digital temperature increases to the set temperature then stops. However the element continued to heat until manually turned off. I had an oven thermometer and it went over the highest reading of 600 FRepaired
woodbridge, Virginiafef377badbnoneself clean motor keeps runningBeyond Repair
Mohnton, PennsylvaniaFEF352BADAN/AOven element heats up as soon as stove is plugged in without ever turning oven on. This has occurred since using self-cleaning oven and the oven probe went and overheated. It happens even after new probe installed.Timer inspected, no repairs necessary
Chapmansboro, TennesseeFEF352BADANONEThe relay closes for the bake cycle but does not open at the set temperature. The bake element stays on all the time during the bake cycle. If cancel is pushed it will shut off. I checked the temperature probe resistance with an ohm meter and it meets the specs in the service data sheet. When the bake cycle is put on you can watch as the digital temperature increases to the set temperature then stops. However the element continued to heat until manually turned off. I had an oven thermometer and it went over the highest reading of 600 FAwaiting receipt of timer
Millen, GeorgiaFEF367CATBN/ADoor lock motor keeps running. If you have another timer in stock please let me know.Awaiting receipt of timer