Wapwallopen, Pennsylvania | Maytag | CWEW6800ACB | (none) | blank display, small aux relay board buzzes constantly, no buttons work | Repaired |
Mandeville, Louisiana | Maytag | 9855VVV | none | blank display, no buttons work, and relay board buzzes continuously | Awaiting receipt of timer |
New Springfield, Ohio | Jenn-Air | 27100 | N/A | Oven would heat but no control over temp time operation etc. Failed during cleaning cycle. | Repaired |
HUNTSVILLE, Alabama | Maytag | CWE7800ACE | N/A | TIMER BUZZES CONSTANTLY | Repaired |
Roman Forest, Texas | Maytag | 9855VVV | N/A | We heard a sound & saw a flash the clock went wild we re set the breaker and all seamed well but the burner only does 1/2 heat and will not turn off. the oven will reach above 300 but we do not know how high. I flip the breaker to off to turn off the oven. | Awaiting receipt of timer |
Cartersville, Georgia | Maytag | CWE6800A | ? | Stopped working after power outage | Repaired |
Stillwater, Minnesota | Jenn-Air | Jenn air W27100B | F 2 | Originally we got a F2 error. I replaced the heat sensor. The error seemed to go away, but the oven took forever to get up to temp. Then I turned on the broiler and it won't turn off. Pushing the cancel button would silence the beeping for a while, but it would again show an F2 or F3 code, and start beeping. I ended up turning of the circuit breaker. I tried to stove again yesterday and when I turned on the oven to bake, only the broiler came on. | Repaired |
Cartersville, Georgia | Maytag | CWE6800A | N/A | Timer stopped working after a loss of power | Repaired |
League City, Texas | Jenn-Air | 27100 | N/A | last one broke, need a new or reconditioned one | Awaiting receipt of timer |
Tallapoosa, Georgia | Magic Chef | magic chef | N/A | would not broil | Awaiting receipt of timer |
Springfield, Virginia | Jenn-Air | w27100b | N/A | the oven was working and then would not turn off. the bake element come on and stays on when the breaker (to the over) is turned back on.
the touch pad does not respond (turn off the oven, etc.) | Repaired |
League City, Texas | Maytag | | None | blank display, small aux relay board buzzes constantly, no buttons work | Beyond Repair |
Statesville, North Carolina | Maytag | CWE6800ACE | none | board just humms----- no display---no fault codes--- | Awaiting receipt of timer |
Kennebunk, Maine | Jenn-Air | ww27110b | None that I could se | Cannot use the temperature control buttons to raise the temp or set time. Only can lower temperature or run through 24 hours to set time. Switch appears okay however extension to push button skin area is broken off. | Repaired |
Idyllwild, California | Jenn-Air | w27100w | none showing | it doesn't do the function requested by pushing the buttons, and does things like lock the door when it shouldn't | Repaired |
La Habra, California | Magic Chef | 9855vvv | N/A | down temperature not working. clock is changing time when down temp is pushed | Awaiting receipt of timer |
Chapel Hill, North Carolina | Jenn-Air | | N/A | cant see display | Awaiting receipt of timer |
Cupertino, California | Maytag | CWE6800ACE | None | When main power is turned on there is a continuous buzzing sound. The display is blank with no error codes. The oven is completely in operational. | Repaired |
Socorro, New Mexico | Jenn-Air | WW27110B | N/A | double oven and top oven does not turn on. repair person said it was the control board but part not avialalbe | Repaired |
Harper, Texas | Jenn-Air | W27100B | none | The temperature increase presser is broken. When increasing temperature above 350 degrees, element will not work. | Repaired |
Kent, Washington | Jenn-Air | Jenne Air WM27160B | F-2 | Broiler comes on and won't turn off. | Awaiting receipt of timer |
Fort Worth, Texas | Jenn-Air | W27100W | power surge from pow | Control board/panel does not power up. Failure due to power outage from power company and subsequent surge when power restored to house. Smells like burnt bakelite. | Awaiting receipt of timer |
marshall, Virginia | Maytag | | N/A | oven bake will not come one it goes tobroil | Awaiting receipt of timer |
Chantilly, Virginia | Jenn-Air | ww27110B | F2 | During baking, Broiler will turn on and create an overheat condition. Usually, we can turn off the breaker, let the oven cool, and then turn it back on. Recently, the broiler now turns on immediately when power is restored to the oven. | Replaced with reconditioned timer |
Poulsbo, Washington | Jenn-Air | WW27110 | F2 | Broiler coil is stuck on. If new or reconditioned oven control board is not available, we are willing to consider sending ours in for repair. | Repaired |
Anchorage, Alaska | Whirlpool | CWE7800ACB | Bad button for uppin | Cannot raise temperature but can lower it. | Awaiting receipt of timer |
Poulsbo, Washington | Jenn-Air | WW27110 | F2 | Broiler element turns on and will not turn off unless power breaker is shut off. | Repaired |
Indianapolis, Indiana | Magic Chef | 9855vvv | N/A | had a buzzing noise and went blank | Repaired |
Aurora, Ohio | Jenn-Air | ww27110w | f-2 | power outage-power restored- turned top oven on to bake -got code of f 2 shuts off bake and broiler turned on in top oven. contact points in one of the relays look in poor condition | Awaiting receipt of timer |
ceres, California | Maytag | cwe7800 ace | N/A | when you press bake it jumps to broil every time. top oven not working | Repaired |
Comanche, Texas | Maytag | Cwe7800ace | N/A | Can't increase heating | Repaired |
Baton Rouge, Louisiana | Jenn-Air | W27100B | N/A | No clock, no display, key pad won't function, no sound, power is good. | Repaired |
Andover, Connecticut | Maytag | w27100w | N/A | takes forever to heat up then will not stay at a temperature go higher or shut off. | Repaired |
Skiatook, Oklahoma | Jenn-Air | W27100W | N/A | Up down arrows to change temperature, run timer, etc. stopped working. Upon removal of timer, see that button top and connector below were broken off for this function | Repaired |
Greens Fork, Indiana | Jenn-Air | W27100W | N/A | Temperature selector for increasing not working | Awaiting receipt of timer |
Caldwell, Texas | Jenn-Air | W27100w | F2 | Oven comes on and want turn off, and touch pad won’t work unless breaker is turned off. Then after sitting overnight turn breaker on then it may or may not work. F2 code every now and then. Before this broiler would not work. Please contact me! I need to ask some questions | Awaiting receipt of timer |
Charleston, South Carolina | Jenn-Air | W27100W | N/A | the oven will only go up to 350 degrees when you try to set it to a higher temperature | Repaired |
Livonia, Michigan | Maytag | CWE6800ACB | N/A | temp up arrow doesn't work
temp down arrow is intermittant | Repaired |
Little Meadows, Pennsylvania | Maytag | CWE6800ACE | No code, BAKE button | Bake button does not work/. Ser # 12084730UQ | Repaired |
Scandia, Minnesota | Jenn-Air | WM27160W | wont set temp..goes | wont set temp..goes to broil
do you have any in stock? | Repaired |
denton, Texas | Jenn-Air | W27100W | N/A | Hello! The oven will only go up to 350 degrees when you try to set it to a higher temperature. Do you have any of these parts on hand for purchase? We need it asap and could then send in ours if needed. Look forward to hearing from you!
817-5xx-xxxx
t...@gmail.com | Awaiting receipt of timer |
Redwood City, California | Jenn-Air | W27100B | n/a | Oven exhibits no signs of life except for hum.
Previous inquiry 12/29/21 2:10PM Pacific
Oven failed after wide area power outage. Now no lights or anything other than low frequency hum. Service rep said likely control panel or relay. Timer failure consistent with your site page about this timer (nice touch by the way). | Repaired |