Whirlpool WHP54803 Free Standing - Electric Timer

Washing machine goes through the wash/agitate cycle fine but will not advance to the rinse or spin cycle. Do I need to replace the clock or is there possibly something else wrong? Please help.....

Our Whirlpool runs great . . . except that you almost always have to lift the lid to get it to engage in the spin cycle. Could this be a clock problem and can I fix it myself?

model # whdsr315daww I have replaced the clock . but I still have same problem the water does not shut off & does not go to next cycle .this has spilled water three times . any ideas??

Dear Appliance Parts Pros.com Discount Appliance Parts – Appliance Repair Parts Call Toll Free: 1-877-477-7278 California Office: 16501 Ventura Blvd, Ste 514, Encino, CA 91436 Tennessee Office: 240 Edwards St. S.E., Cleveland, TN 37311 I have a Whirlpool Freezer: Model: EV201NXMQ02 L1 Serial: EWR1463296 Refrigerator Defrost clock Manufacturer Model: 4357124 Age: It is 6 years old. Problem: Intermittently, the food in the freezer defrosts for no apparent reason (No power interruptions, door is tightly closed, freezer temp is set correctly, etc.) For the following reasons, it appears to me that the defrost clock is intermittently malfunctioning: a. The evaporator fan does not always come back on after the defrost cycle should have had plenty of time to complete. The evaporator fan is off even though the compressor is running. 1. Often, if I do not manually advance the defrost clock, the compressor runs continuously, but the evaporator fan never comes on and eve

Washing machine fills for wash cycle. It agitates and then drains after wash cycle. Will not refill for the rinse cycle. Then won't go into spin cycle. I can hear the clock running but doesn't seem to advance into the rinse or spin cycle. Have replaced the lid switch assembly and the pressure switch/tube. Still no results. What is going on here???????

Washer Cycles Continus And Wont Drain Or Shut Off.clock Problem?

My washer is buzzing before it goes to next operation on the clock/controller. Sometimes it does not go to next operation. What do I need to do?

When I start my washer, I should be able to push in control knob and turn the clock knob with it. Now I have to manually turn the clock knob (which is kind of a pain). Once the washer starts, the clock works fine. Do I need a new clock knob or some clip to get it engaged?