Amana ACF3325AW Gas Range Timer

Amana gas oven model acf3325aw temperature is 100 degrees off

Amana Big Oven ACF3325AW oven wont light. range top works and broiler works. Oven won't heat.

I have a gas oven with a oven door that requires adjustment. How do I do it. It's an Amana ACF3325Aw

model acf3325as, oven is not turning on. it looks like the electric igniters are working, but no gas supply to oven. the top burners are all functioning properly

i have an amana air condictioner, that when i turn power on the digital read out for space temp reads 32 deg.

My oven burners work. My broil works but when setting a temp for my oven to bake...the preheat light comes on but NO heat! I have had to replace the heat sensor a couple times since purchasing it but that was because the oven kept heating to a high level no matter what the temp was set to. Is the sensor once again the culprit? What is the problem with my oven this time???

Both ignitors glow hot, but no gas flow, no bake, broil, or clean. No error codes. Burners work fine. Reading through as many posts as I can, general advice would be to replace the ignitors. Is it likely that both of them are weak? Just thought I best ask before I start part swapping. And it looks like there is only one gas valve, so that is not likely to be a problem if the burners work, yes?

my right front burner would not shut off so I turned the gas off on the gas line to the range. I replaced the valve with part# ap4041810 and now the burner will light and shut off , but it will go out when I try to turn it to low.It woprks find on high and med. What could be the problem?

Oven does not work, neither Broiler nor Bake, clock & control panel appear to work, top burners work fine. I set the oven for a 3 hour self clean, using Maytag directions, no trouble doing so before this, nor this time, but...now the small red oven light indicator does not go on, nor does the oven work-heat, either for "Bake" or "Broil". There is no error code that shows up on the controls. (Have not tried "Timed Bake", never use it, but DID try Clean cycle again, as per instructions, for a 30 min. cleaning....clock and lock appear to work fine, and shut off fine, but no heat. ) I can see....from what I have read in present forum listings, that apparently it is better not to use the self-cleaning cycle at all....true?) (If it's a thermal fuse switchout, where is the fuse located? Don't see it on any of the four exploding charts for this model...I can check for continuity if I can find it...) Any ideas gratefully received.